Installation of Align Tools (ATools)
The ATools utility can be downloaded HERE
NOTE: This utility must be installed on the computer running Wasatch SoftRIP.
Double-click the file that was downloaded to begin the installation process.
Click Next.
![AT1 AT1](http://localhost/wp-content/uploads/2023/09/AT1.jpg)
Click Next to install the program into the default location.
![AT2 AT2](http://localhost/wp-content/uploads/2023/09/AT2.jpg)
For the program to work properly be sure to install any additional components.
Click Next.
![AT3 AT3](http://localhost/wp-content/uploads/2023/09/AT3.jpg)
Set the Start Menu folder.
Typically the default location that is displayed will be a good choice.
Click Next to continue with the installation.
![AT4 AT4](http://localhost/wp-content/uploads/2023/09/AT4.jpg)
Verify the information displayed is what was previously selected, then click Install.
![AT5 AT5](http://localhost/wp-content/uploads/2023/09/AT5.jpg)
Once the installation is complete, a window similar to the one on the right will be displayed.
Click Finish to close the installation wizard.
![AT6 AT6](http://localhost/wp-content/uploads/2023/09/AT6-1.jpg)
After clicking "Finish", the installation of the ATools utility is complete.
You can now close this window.